This Hunter wall control model 24758 is a 240V 3 speed wall control and is for use with a Hunter ceiling fan only. The pack contains two face plates for your selection of square or rectangle. We also have a model with a light switch if preferred – model 24757. If you have a light on the fan that you wish to switch on/off independently of the fan then will require 4-core wiring to be run to your ceiling fan to provide the addional “switched live” wire for the light.
Please note that if your fan comes with pull chains then once the wall control is installed the pull chains must NOT be pulled otherwise you risk damaging the fan. This can limit the speed of the fan or cause a humming noise to be emitted which may or may not be cured by resetting the control. Please follow installation instructions carefully to avoid problems. We advise cutting the pull chains short so that they are only used for resetting the wall control.
NB: These can only be used with fans that are capable of adapting to wall controls ie “wall control adaptable” otherwise they will not work – please check with our office if you are unsure.